Heat rejection comes first
A chiller can only perform if it can reject heat. On an air-cooled unit that means the condenser coil and the fans that pull air through it. In the northern suburbs, dust is the main enemy, and a coil that looks acceptable from a distance is often blocked deep in the fin pack.
A proper visit measures approach temperature rather than simply washing the coil. If the unit is not rejecting heat as it should, the reason is either airflow, fouling or refrigerant, and the readings say which.
Then the water side and the safeties
Flow, pressure drop and water treatment decide how efficiently the machine transfers heat. Strainers, pumps and differential pressure switches are checked because a slow flow problem looks exactly like a capacity problem from the plant room.
Safety controls are tested rather than assumed: high pressure, low pressure, flow interlocks and antifreeze protection. These are the devices that turn a fault into a shutdown instead of a compressor failure.
Finally, the control sequence
Staging and set points drift over years of adjustments. Reading the actual sequence against the design intent is where efficiency is usually recovered, and it costs nothing but attention.
Ask for the readings, not just an invoice. A report that lists measured values, findings and recommendations is the difference between maintenance and a wash-down.