5 min read

Freezer room ice build-up: four causes worth checking first

Why ice appears on the evaporator, the floor or the door frame of a freezer room, and what each pattern tells you about the fault underneath.

Ice on the evaporator means defrost

A light frost is normal. A solid block that closes the fin gaps is not. It usually means the defrost heaters, the termination sensor or the control settings are not completing a full cycle, so each frost is added to rather than cleared.

The symptom people notice first is reduced pull-down: the room runs constantly and still struggles after a delivery. By then airflow has often been restricted for weeks.

Ice on the floor means the drain

Water that should leave through the drain is freezing on the floor instead. The common causes are a blocked drain, a failed drain heater or trace, or a fall that was never correct. Once the drain freezes, the room starts holding water as well as cold.

This is the one to fix immediately. Melt water finds floor finishes, stock packaging and door gear, and the repair grows with every week it is left.

Ice on the frame or around the door

Ice around a door frame points at the envelope rather than the plant: a hardened gasket, a closer that no longer latches, a damaged heated frame or a threshold that has been damaged by trolleys.

Every opening admits moist air that the evaporator must turn into ice. A door that seals properly reduces the load on the plant more than a larger unit would.

Keep reading

Other guides

Enquire

Ask about your own property

If this guide raised a question about your system, send the details and we will answer it directly.

We use your details only to respond to this enquiry. No marketing lists.

Next step

Tell us what the system is doing. We will tell you what it needs.

Send an enquiry with the property type, the service and a short description of the fault. We reply with the next practical step, and we do not use pressure or invented urgency.